Honda Tire Shop in Mentor, OH

What Does Balancing Tires Mean?

What does balancing tires mean? Tire balancing equally distributes the weight of the tire and wheel assembly to spin smoothly at high speeds. Tires can become out of balance with normal tire wear. All four tires and wheels may be balanced during a tire rotation and when new tires are installed.

When we balance your tires, we use special equipment to spin the tire and wheel assembly and measure any vibrations that occur. Our technicians then install wheel weights as needed to eliminate the vibrations and ensure a smoother, more enjoyable drive through Mentor and Painesville.

When Should Tires Be Replaced?

New tire tread depths typically start at roughly 9/32″ to 12/32″, and the U.S. Department of Transportation mandates that tires be replaced when tread depth falls to 2/32″ or lower. Of course, replacing your tires before they reach this point is always a good idea—and our tire shop in Mentor, OH has you covered. Make sure your tires’ tread depths are sufficient for road and weather conditions.

Monitoring normal tread wear helps plan for future tire replacement. Uneven or irregular tread wear can indicate problems with tire pressure, wheel alignment, tire balance, or lack of rotation, and you can learn a lot by getting up close and personal with your tires before you head out on the highway.

What is the Proper Tire Pressure?

Properly inflated tires provide the best combination of handling, tread life, and comfort on the roads of Eastlake and Willoughby. The air pressure inside the tires supports the weight of the vehicle. Tire pressure is the inflation pressure specification, measured in Pounds per Square Inch (PSI), for a given tire type, size, and application.

Honda tire pressure guidelines generally tell you to keep your tires between 30 and 35 PSI, although precise guidelines may vary from model to model, or depending on the kind of tires you’ve equipped.

You can usually find the proper tire pressure for your Honda Civic or your Honda CR-V on the driver’s side door jamb, but you can always give us a call if you’re uncertain! Because tires can lose 1 to 2 PSI of tire pressure per month, tire pressures must be checked regularly.

What is a TPMS?

Since 2008, every Honda has been equipped with a Tire Pressure Monitoring System (TPMS) that monitors the pressure in all four tires and alerts the driver if pressure in any tire becomes significantly low. Drivers should also regularly check their tires’ pressure using an accurate gauge.

Some Honda TPMS systems have battery powered sensors inside the wheels. Batteries inside these sensors have an expected lifespan of 7 – 10 years. When a battery in any sensor fails, an indicator on the instrument panel comes on and the system will no longer monitor the tire pressure.

What is a Tire Rotation?

You know that your tires need regular check-ups, but what is tire rotation? During tire rotation, at the time of service, the tire and wheel assemblies are moved from one position to another to more evenly distribute wear and maximize tire life. The rotation pattern depends on the vehicle and tire design. Because the front tires turn and pull the vehicle forward, front tires wear differently than rear tires.

If you buy new tires from an authorized retailer—like our tire shop in Mentor, OH—they may be protected by warranty coverage. Tire rotation is regular maintenance that should be performed as recommended and is required to maintain this coverage! (Consult the tire manufacturer’s warranty booklet provided with the vehicle for more details.)

What is Wheel Alignment?

A wheel alignment is the adjustment of angles that the tires make in relation to the road surface and each other. The primary alignment angles are camber, caster, and toe.

A wheel alignment is often performed after replacing tires or suspension components, after an impact with a pothole or curb, or when the following conditions occur: abnormal tire wear, an offset steering wheel or handling concerns (drifting, pulling, wandering, darting).

Our technicians measure alignment angles using sophisticated equipment, then adjust or possibly replace suspension components as needed to set the alignment to original Honda specifications.

Why service your vehicle at our Dealership?

Value and Trust

Our dealership strives to offer the same things people choose a Honda vehicle for, including reliability, dependability, and value. Our Parts and Service Department is committed to earning your loyalty every time you visit and helping you prolong the life of your vehicle.

Honda Professionals

Our Dealership Parts and Service personnel are trained professionals and are continually provided leading-edge customer service, process, and technical training. Combine that with up-to-date technical resources, specialized processes, and specific tools for your exact model and year, and you’ve got the right people to help make maintaining your Honda as satisfying as owning it.

Please don't hesitate to direct your service questions to us! Fill out the simple form below and our technicians will get back to you.
  • This field is for validation purposes and should be left unchanged.
Honda of Mentor is located at: 8555 Market St • Mentor, OH 44060

Get Directions

8555 Market St, Mentor, OH, 44060
Honda of Mentor 41.689372, -81.334018.